Fuller: Difference between revisions
From Cunnan
Jump to navigationJump to search
No edit summary |
m (Fixing red link) |
||
| Line 3: | Line 3: | ||
During a [[thrust]], however, the groove weakens the blade if the fuller is large. Consequently thrusting blades such as a [[rapier]] typically have a [[diamond blade]] cross-section. |
During a [[thrust]], however, the groove weakens the blade if the fuller is large. Consequently thrusting blades such as a [[rapier]] typically have a [[diamond blade]] cross-section. |
||
This groove may be found at the back of a [[ |
This groove may be found at the back of a [[backsword]] or in the centre of a two-edged [[sword]]. |
||
[[category:weapon parts]] |
[[category:weapon parts]] |
||
Revision as of 17:50, 6 April 2007
A fuller is a groove positioned into the surface of a blade in order to lighten the blade. The loss in strength of the blade is reduced as the centre of a blade does not significantly undergo either tension or compression during a cutting stroke.
During a thrust, however, the groove weakens the blade if the fuller is large. Consequently thrusting blades such as a rapier typically have a diamond blade cross-section.
This groove may be found at the back of a backsword or in the centre of a two-edged sword.
